← Back to Eduqas A-Level Design and Technology

    Exam-style questions by topic — Eduqas A-Level Design and Technology

    One question for each of 7 topics. These are written for this specification by MasteryMind. They are not past-paper questions, and they are not from Eduqas.

    1. Semiconductors and Diodes

      A silicon sample is doped with phosphorus atoms. What type of semiconductor is formed and what is the primary effect on its conductivity?

      Practise Semiconductors and Diodes
    2. Transistors and Amplifiers

      What is the main purpose of the emitter bypass capacitor in a common emitter amplifier?

      Practise Transistors and Amplifiers
    3. Operational Amplifiers

      An op-amp has a slew rate of 0.5 V/µs. If the output is required to change from -10 V to +10 V, what is the minimum time this transition will take?

      Practise Operational Amplifiers
    4. Digital Electronics

      A combinational logic circuit is required to output a HIGH signal when a 4-bit binary number is greater than 9. Which type of circuit is most suitable for this task?

      Practise Digital Electronics
    5. Timing Circuits

      In an RC timing circuit, if the resistance is increased while the capacitance remains constant, what happens to the time constant?

      Practise Timing Circuits
    6. Power Supplies

      A 5 V voltage regulator is used to power a microcontroller that requires a stable supply. If the input voltage is 12 V and the regulator is a linear type, what happens to the excess power?

      Practise Power Supplies
    7. Measurement and Testing

      An oscilloscope is used to measure a square wave signal. The signal has a peak-to-peak voltage of 6 V. If the V/div is set to 2 V/div, how many divisions will the trace occupy vertically from bottom to top?

      Practise Measurement and Testing

    Practise every topic and see your weak topics.

    Start free

    A week of Premium from your first lesson · Then the free plan continues · No card, no charge