Skip to topic
    ← Back to course topics

    Topic 15 – Forces and matter — Edexcel GCSE Combined Science

    Topic 15 – Forces and matter explained

    This core practical links Hooke's law to energy.

    Read the full explanation

    Set up a spring clamped vertically with a mass hanger and metre rule, and record the natural length. Add slotted masses one at a time, recording the weight added (W = mg, using g = 9.8 N kg⁻¹) and the new length; extension e is the increase in length, found by subtracting the natural length. Plot force against extension: a straight line through the origin shows Hooke's law holds, and its gradient gives the spring constant k in N m⁻¹. The work done stretching the spring equals the elastic potential energy stored, the area under the force–extension graph, E = ½Fe = ½ke². Calculate this for each load and compare with the force–extension data. Repeat readings, use small increments, and note where the line curves as the elastic limit is passed.

    Your focus

    1. Carry out the practical to collect force and extension data for a spring.
    2. Calculate the spring constant and the work done/energy stored from the data.
    3. Evaluate the reliability of results and identify where Hooke's law stops applying.

    Topic 15 – Forces and matter exam tips

    Marking Points
    • Describes a valid method: clamp the spring vertically, measure natural length with a metre rule, add masses in equal increments and record each new length.
    • Calculates extension correctly as new length minus natural length, and weight as W = mg with g = 9.8 N kg⁻¹.
    • Plots a force–extension graph, identifies the straight-line region through the origin as Hooke's law, and finds the spring constant from the gradient in N m⁻¹.
    • Calculates work done/energy stored using E = ½Fe or E = ½ke², recognising this equals the area under the force–extension graph.
    • Evaluates reliability: repeats, small increments, avoiding overloading past the elastic limit, and identifying where the graph curves.
    • Uses consistent SI units (metres, newtons, joules) and comments on sources of uncertainty such as parallax when reading the rule.
    Examiner Tips
    • 💡Always state the controlled variables (same spring, vertical set-up, reading at eye level) and how extension is measured.
    • 💡Show the calculation of one energy value fully, including substitution and units, before generalising.
    • 💡Link the shape of the graph to Hooke's law and the elastic limit rather than just describing it.
    Common Mistakes
    • Confusing extension with total length: the error is using the full length in place of extension; the correction is to subtract the natural length to obtain the extension.
    • Using g = 10 N kg⁻¹ inconsistently or forgetting to convert grams to kilograms; the correction is to convert mass to kg and use g = 9.8 N kg⁻¹ throughout.
    • Treating the gradient as the spring constant without checking units; the correction is to state the gradient is in N m⁻¹ and equals k only in the straight-line region.