Skip to topic
    ← Back to course topics

    Topic 7 – Rates of reaction and energy changes — Edexcel GCSE Combined Science

    Topic 7 – Rates of reaction and energy changes explained

    Activation energy is the minimum energy that colliding particles must have for a reaction to happen.

    Read the full explanation

    Even when particles collide, most collisions do nothing because the particles are moving too slowly. Only collisions with at least this minimum energy can break the bonds in the reactants and let new bonds form in the products. On a reaction profile it is shown as the energy gap between the reactants' energy level and the top of the curve, the peak. A small activation energy means many collisions succeed, so the reaction is fast at room temperature; a large activation energy means few collisions succeed, so the reaction is slow unless it is heated or a catalyst is added. A catalyst lowers the activation energy by providing an alternative pathway.

    Your focus

    1. Define activation energy as the minimum energy colliding particles need to react
    2. Locate activation energy on a reaction profile as the energy gap from reactants to the peak
    3. Relate the size of the activation energy to the rate of reaction and to the effect of a catalyst

    Topic 7 – Rates of reaction and energy changes exam tips

    Marking Points
    • States that activation energy is the minimum energy that colliding particles need for a reaction to occur
    • Identifies the activation energy on a reaction profile as the energy difference between the reactants and the peak of the curve
    • Explains that only collisions with energy at or above the activation energy lead to a reaction
    • Links a low activation energy to a faster rate because a greater proportion of collisions are successful
    • Explains that a catalyst lowers the activation energy by providing an alternative reaction pathway
    Examiner Tips
    • 💡Learn the definition word for word as the minimum energy colliding particles need to react, then apply it to a profile rather than only reciting it
    • 💡When a question shows a profile, measure activation energy from the reactants' level up to the peak, not from the products
    • 💡Use the phrase 'proportion of successful collisions' to link activation energy to rate, which earns explanation credit
    • 💡Check whether the question asks for a definition or an application, and answer the one actually set
    Common Mistakes
    • Confuses activation energy with the overall energy change of the reaction; keep the two separate, since activation energy is measured to the peak while the overall change is measured between reactants and products
    • Describes activation energy as the energy released when bonds form; correct this by stating it is the minimum energy needed to start the reaction, not energy given out
    • Claims that every collision between particles causes a reaction; correct this by saying only collisions with enough energy succeed
    • Treats a catalyst as increasing the energy of the particles; correct this by saying a catalyst lowers the activation energy instead