Skip to topic
    ← Back to course topics

    Forces and stresses - Materials and objects can be manipulated to resist and work with forces and stresses — AQA GCSE Design and Technology

    Forces and stresses - Materials and objects can be manipulated to resist and work with forces and stresses explained

    Five stress types describe how a force loads a material.

    Read the full explanation

    Tension pulls a material apart along its length, as a cable does when it hangs a load. Compression pushes it together, as a pillar does under a roof. Bending combines tension on one face with compression on the opposite face, as a shelf does under books. Torsion twists a component about its axis, as a screwdriver shaft does when turned. Shear slides one part of a material past another across a plane, as a bolt does when two plates are pulled in opposite directions. Learn each definition with a physical action and a product example, then match the stress named in a question to the correct description rather than to a similar-sounding one.

    Your focus

    1. Define tension, compression, bending, torsion and shear accurately.
    2. Match a described loading situation to the correct stress type.
    3. Distinguish similar stress types by the direction and nature of the force.

    Forces and stresses - Materials and objects can be manipulated to resist and work with forces and stresses exam tips

    Marking Points
    • Defines tension as a pulling force that stretches a material along its length.
    • Defines compression as a pushing force that shortens a material.
    • Explains bending as tension on one face combined with compression on the opposite face.
    • Describes torsion as a twisting action about an axis.
    • Describes shear as forces causing one part of a material to slide past another.
    Examiner Tips
    • 💡Attach a physical action to each stress type so similar terms cannot be swapped in the options.
    • 💡Check the direction of the force in the question before choosing between tension and compression.
    • 💡Reject any option that names a stress without describing how the force acts on the material.
    Common Mistakes
    • Confuses torsion with bending; link torsion to twisting about an axis and bending to opposing faces under tension and compression.
    • Describes shear as a simple pull; identify the sliding of one part past another across a plane.
    • Treats compression as stretching; state that compression pushes material together and shortens it.