The use of programmable components to embed functionality into products in order to enhance and customise their operation — Edexcel GCSE Design and Technology
The use of programmable components to embed functionality into products in order to enhance and customise their operation explained
A programmable component reads inputs, applies a decision and then drives an output either on or off.
Read the full explanation
Teach the chain as three links: the input supplies a condition (for example a push-to-make switch reading high when pressed, or a light-dependent resistor whose voltage falls in darkness), the program tests that condition with a decision such as IF input = 1 THEN output = 1 ELSE output = 0, and the output device (LED, buzzer, motor via a driver transistor) is switched accordingly. Stress that the decision, not the input alone, sets the output state, and that a system can invert the relationship: a door alarm sounds when the switch reads 0 because the door has opened. Learners should trace a simple flowchart or pseudocode line by line, state the output for a given input, and recognise that outputs may be latched (stay on after the trigger) or momentary.
Your focus
- Trace a simple program that reads an input and switches an output.
- State the output state produced by a given input and decision rule.
- Explain how a decision links an input condition to an output action.
The use of programmable components to embed functionality into products in order to enhance and customise their operation exam tips
Marking Points
- Identifies the input device that supplies the condition the program tests.
- States the decision rule that links the input value to the output state.
- Gives the resulting output state for a specified input condition.
- Explains that the program, not the input alone, determines whether the output switches on or off.
- Recognises an inverted relationship where a low input switches an output on.
Examiner Tips
- 💡Trace the flowchart or pseudocode in order: read input, apply decision, set output.
- 💡Name both the input component and the output component in your answer.
- 💡State the output value explicitly for the input condition given in the question.
Common Mistakes
- Assumes the output always follows the input directly; check the decision rule, which may invert or latch the state.
- Confuses the sensor with the output device; name the input component and the output component separately.
- Ignores the decision step and describes only the input and output; include the test that connects them.