Skip to topic
    ← Back to course topics

    Using and interpreting engineering data and documentation — EAL Vocational Motor Vehicle & Transport

    Learning outcomes

    1. Demonstrate the required behaviours in line with the job role and company objectives;2.
    2. Use oral, written, electronic and IT based methods and systems for the accurate communication, reporting & recording of technical and other information and use out all of the following:2.1 oral based methods and systems;2.2 written based methods and systems;2.3 electronic based methods and systems;2.4 IT based methods and systems;3.
    3. Use the approved source to obtain the required data, documentation or specifications and carry out all of the following: 3.
    Show all 17 objectives
    1. check the currency and validity of the documentation used;3.
    2. exercise care and control over the documentation at all times;3.
    3. correctly extract all necessary data in order to carry out the required tasks;3.
    4. seek out additional information where there are gaps or deficiencies in the information obtained;3.
    5. report any problems found with the data, documentation or specifications;3.
    6. make valid decisions based on the information extracted;3.
    7. return all documentation to the approved location on completion of the work;4.Extract and interpret information from engineering drawings and other related documentation;5.Extract information that includes three of the following:5.1 materials or components required; 5.2 connections to be made;5.3 dimensions; 5.4 processes or treatments required;5.5 dismantling/assembly sequence required; 5.6 installation requirements;5.7 location/orientation of parts; 5.8 tolerances and quality requirements;5.9 circuit characteristics (such as pressure, flow, current, voltage, speed);5.10 test points;5.11 inspection requirements; 6.
    8. Use terms and information extracted from engineering drawings and related documentation to establish work requirements, to include four of the following:6.1 general assembly drawings; 6.2 routing diagrams (such as piping, cables etc);6.3 fluid power drawings; 6.4 layout diagrams (such as schematic, block, physical, system);6.5 wiring/circuit diagrams; 6.6 approved sketches;6.7 installation drawings; 6.8 technical illustrations;6.9 manufacturers' manuals/drawings;6.10 visual display screens;6.11 photographic images;7.
    9. Use information extracted from related standards, templates and certifications to establish work requirements to include four from the following:7.1 standard operating procedures;7.2 maintenance log/reports ; 7.3 reference tables/charts (such as logic tables, ladder diagrams);7.4 fault diagnosis guides; 7.5 national, international and organisational standards;7.6 test schedules; 7.7 health and safety standards relating to activity (such as COSHH); 7.8 test results; 7.5 environmental requirements/information;7.6 manufacturers' instructions;8. If applicable report any inaccuracies or discrepancies in documentation and specifications.9. Deal promptly and effectively with any problems within their control and report those which cannot be solved.1.
    10. Explain what information sources are used for the data and documentation that they use in their work activities.2.
    11. Explain how documents are obtained, and how to check that they are current and valid.3.
    12. Explain the basic principles of confidentiality (including what information should be available and to whom).4.
    13. Describe the different ways/formats that data and documentation can be presented (such as such as drawings, job instructions product data sheets, manufacturers’ manuals, financial spreadsheets, production schedules, inspection and calibration requirements, customer information).5.
    14. Explain how to use other sources of information to support the data (such as electronic component pin configuration specifications, reference charts, standards, bend allowances required for material thickness, electrical conditions required for specific welding rods, mixing ratios for bonding and finishing material

    Using and interpreting engineering data and documentation assessment help

    Unit assessment details

    Loading assessment details…