Skip to topic
    ← Back to course topics

    Mechanical devices - Changing magnitude and direction of force — AQA GCSE Design and Technology

    Mechanical devices - Changing magnitude and direction of force explained

    A first-order lever places the fulcrum between the effort and the load, so the effort and the load act on opposite sides of the pivot.

    Read the full explanation

    Pressing down on one end lifts the load at the other, which reverses the direction of the force. The distances from the fulcrum set the magnitude change: a long effort arm and a short load arm give a larger output force than input force, while the reverse arrangement gives a smaller output force but a larger movement. A crowbar pivoting on a block, or a pair of scissors, shows this arrangement. In a multiple-choice question, identify which component sits between the other two before choosing the answer.

    Your focus

    1. Identify the fulcrum, effort and load in a first-order lever.
    2. Explain how a first-order lever changes the direction of a force.
    3. Describe how arm lengths change the magnitude of the output force.

    Mechanical devices - Changing magnitude and direction of force exam tips

    Marking Points
    • Identifies the fulcrum as the component positioned between the effort and the load in a first-order lever.
    • States that a first-order lever reverses the direction of the applied force.
    • Explains that the ratio of effort arm to load arm changes the magnitude of the output force.
    • Selects the option that matches the arrangement of fulcrum, effort and load rather than a familiar object alone.
    Examiner Tips
    • 💡Sketch the three components in order before reading the options, then match your sketch to one option.
    • 💡Check both clauses of the question: direction change and magnitude change may each be tested.
    • 💡Eliminate options that place the load in the middle, because that describes a different order.
    • 💡Read the whole option, since a partly correct statement can still be wrong about direction.
    Common Mistakes
    • Places the load between the fulcrum and the effort; correct this by locating the fulcrum in the middle for a first-order lever.
    • Assumes a lever cannot change direction; correct this by noting that a first-order lever reverses the force direction.
    • Treats a longer effort arm as reducing output force; correct this by linking a longer effort arm to greater output force.
    • Chooses an answer from the object named without checking the component order; correct this by identifying fulcrum, effort and load first.