Skip to topic
    ← Back to course topics

    Specialist techniques and processes - How materials are cut shaped and formed to a tolerance — AQA GCSE Design and Technology

    Specialist techniques and processes - How materials are cut shaped and formed to a tolerance explained

    Manufacturing to a tolerance means working to a permitted range between a minimum and a maximum measurement rather than to one exact size.

    Read the full explanation

    A dimension on a drawing might be given as 50 mm with a tolerance of ±0.5 mm, so any part measuring from 49.5 mm to 50.5 mm is acceptable. Tolerances allow for slight variation in machines, tools and materials while keeping parts interchangeable and fit for purpose. Tighter tolerances need more accurate, often slower and costlier, processes; looser tolerances suit parts where a small variation does not affect function. Quality control checks finished parts against the minimum and maximum limits, accepting those inside the range and rejecting those outside it.

    Your focus

    1. Define tolerance as a minimum and maximum measurement range
    2. Calculate upper and lower limits from a stated tolerance
    3. Explain why manufacturers set tolerances on parts

    Specialist techniques and processes - How materials are cut shaped and formed to a tolerance exam tips

    Marking Points
    • Defines tolerance as the permitted range between a minimum and a maximum acceptable measurement
    • Applies a stated tolerance to a nominal dimension to give the upper and lower limits
    • Explains that tolerances allow for small variation in machines, tools and materials while keeping parts interchangeable
    • Links tighter tolerances to greater accuracy, cost or time, and looser tolerances to parts where variation does not affect function
    Examiner Tips
    • 💡Work a quick example, such as 50 mm ±0.5 mm giving 49.5 mm to 50.5 mm, to show you can apply a tolerance
    • 💡Use the words minimum and maximum when describing the acceptable range
    • 💡Explain the trade-off between accuracy and cost when discussing why tolerances are chosen
    Common Mistakes
    • Treats tolerance as a single exact target size; recognise that it is a range with a minimum and a maximum limit
    • Adds the tolerance in only one direction; apply it to give both an upper and a lower limit
    • Assumes tighter tolerance is always better; note that it usually raises cost and time and is only needed where function demands it